SealThane protective finish is designed to seal, protect and enhance the color of brick pavers and decorative concrete.

FEATURES AND BENEFITS:

• Non-Yellowing
• Aliphatic
• Environmenally friendly
• Water-based
• Excellent chemical resistance
• Interior and exterior use
• High performance
• Excellent UV resistance
• Easy clean-up
• May be applied to damp surfaces (no ponding or puddling)

SURFACE PREPARATION:
Dirt, grease, grime and any foreign material must be removed before application of SealThane new coating. Treat surface for mildew. Oil and grease should be scrubbed with a solution of Oxyclean and water or alternate degreaser.  SealThane is water based. Do not Freeze.

APPLICATION INFORMATION:
Combine Part A & Part B and mix thoroughly with gentle agitation for 2-3 minutes. Do not whip air into the material. SealThane has a 2-3 hour pot life once Part A & Part B are combined, therefore, do not mix more than you can apply in that time frame. Apply with airless sprayer or garden sprayer . When spraying, use a tip designed for gloss coatings. Apply when surface and air temperatures are above 50 Deg. F. Do not apply if the threat of rain exists or if moisture or dew may condense on the surface prior to SealThane curing. Cover and protect all vegetation and surrounding areas not being sealed. Do not over apply, soak the substrate or allow product to puddle. Two thin coats are recommended for best performance a second coat may be applied when the first coat is dry to the touch. Do not apply additional coats 36 hours after the first coat was applied. Gloss is determined by the mix ratio you select. Less water will yield a higher gloss.

Note: SealThane must be reduced with water. Select a mix ratio for the desired result.

MIX RATIO:
Mix Part A, Part B and water
For Maximum Performance:
4 Parts A
1 Part B
2 ½ Parts Water

ESTIMATED DRY TIME:
Touch – 30-60 minutes
Recoat – 2 hours
Foot Traffic – 24 Hours
Vehicular Traffic – 48 Hours

MAXIMUM REDUCTION RATIO:
4 Parts A
1 Part B
5 Parts Water

CLEAN UP:
Clean up drips and spills immediately using a damp cloth. Clean tools and equipment with soap and fresh water.

Safety Data Sheet:
SDS

Made in USA